How To Unclog Main Drain Line

One of the first things the technician will do is locate the drain pain and check for standing water.

How to unclog main drain line.

Step 2 check the drain pan. If the toilets are still flushing fine you probably don t have a blocked sewer line. Luckily you can take immediate action to restore your plumbing system to a state of good health. Waste water may drain out when you open the cleanout and when you break the clog.

Next grab the plunger and the drain you are trying to unclog and begin to push and pull at the stick end of your plunger. Most large drain cleaners will also have a cable length of 100 feet 30 m which should be long enough to reach any clog. Remove the plug with an adjustable wrench. Loosen the cap on the drain pipe.

You can start by taking these steps. When you first notice the symptoms of a clogged sewer line turn off the water at the main supply or street level. Turn your water on as hot as it will go and let it run for 5 to 10 minutes to dissolve or break up the clog. Do it slowly and allow it to sit for a few seconds before you remove the cap entirely so you can avoid any sudden spillage.

The first step is to find your main drain cleanout location. To unclog a main drain you ll need a drain cleaner or sewer snake with a 5 8 3 4 in 1 6 1 9 cm diameter cable. The dry condensate pan should be thoroughly cleaned to help prevent the growth of mold. How to unclog a sewer line.

Find a clean out plug located on a large drain pipe in areas such as your basement crawl space garage or near the foundation of your house. Use a pipe wrench to loosen the cap on your main line drain pipe before you open it entirely. To unclog the sewer line with a plunger make sure to stop your water from running if you can. Stand clear as you remove the plug and as you work on the clog.

If standing water is present it can either be soaked up with rags or removed with a wet vac. Fortunately if you notice that your main sewage line is clogged there are several things you can do to remove the block. Get an auger aka a plumbing snake and an adjustable wrench. It usually looks like a small pipe that sticks about 10 to 12 inches vertically out of the ground.

Steps to unclog a main drain line. Loosen the cap on the drain pipe. Your elbows will feel the pressure but you have to keep on going. Put on a pair of goggles and rubber gloves to protect your eyes and hands from contamination.

If you can still flush your toilet or if water is still draining down the sink you may just have partially clogged pipes.